Electric circular duct heaters/preheaters for ventilation systems short version EHC TR..
The electric circular duct heaters/preheaters EHC TR.. are intended to heat clean air in the ventilation systems. Also, heaters/preheaters EHC TR.. can be used for heating or preheating functions with air-handling units. The heaters/preheaters EHC TR.. can be supplied with or without an installed electronic controller, with a pressure and/or flow monitoring system, with a contactor, or produced according to the client's requirements. The heater/preheater EHC TR.. cases are produced from aluzinc-coated metal sheets, sealing rubber for a tight connection with the ventilation duct system. The stainless steel tubes of heating elements are used in the heaters/preheaters.
The heater’s standard temperature setpoint is (0...+30). The other temperature setpoints are possible according to a client’s requirements.
The preheater’s standard temperature setpoints are (-10...+20) and (-30...0). The other temperature setpoints are possible according to a client’s requirements.
Preheaters are additionally insulated.
Benefit:
- Short heater's/preheater's case.
TECHNICAL DATA
- Voltage: 1~230V.
- Output power: 500W...3000W.
- Diameter: 125 mm., 160 mm., 200 mm.
- Degree of protection: IP44.
- Electronic controller types (if equipped): setpoint internal with one duct temperature sensor (model SI), setpoint external with one duct temperature sensor (model SE), control signal 0-10 VDC external (model CE), FC – flow and pressure control, F – flow control.
- Pressure monitoring switch range (if equipped): 0-200 Pa (model SR200).
